PL60 User Manual
(blue) flashes 2 times. Release the feed button and the printer will begin
calibration.The printer can not calibrate in continuous paper mode.
2. Manual positioning learning after closing cover
Users can also complete their calibration through the printer tool software, as
detailed in the "chapter 6 Label Printer Utility Instructions" section.
Note: After the quick calibration, users could open the printer cover to pull
back the paper to avoid paper wasting.
3.5.3 Print Self-test Page
The self-test checks the printer’s current settings, status and whether the printer has
any problems or not. Please confirm the following status.:firmware version, printer
parameter setting status, print quality and external equipment related settings
information, etc. If there are no problems with the printer, please check other
devices or software. This function operates independently of other devices or
software.
1.Printing Manually
1) Make sure the roll is loaded properly.
2) Make sure the top cover of the printer is closed properly. Then turn on the
printer.
3) When the printer is ready, keep pressing the feed button until the light (Blue)
flash once, then release the button to start to print the self-test page.
2.Printing by Windows Driver Program
1) Install the Windows Driver program.
2) Set the “Interface” as the type you use.
To Next Page
Loading...
