Safety and Regulatory Notices | Poly Edge E Series
3
● In order to remove all power from this unit, disconnect all power cables, including any USB or PoE
cables.
Additional Warnings for Products with a Power Supply
● Always disconnect the system from power and telecommunications networks before cleaning or
servicing.
● This product is intended to be powered by an external Limited Power Source (LPS) power supply.
Use only the type which is supplied with this product.
● This system is considered to be Pluggable Equipment Type A. The socket outlets must be installed
near the equipment and be easily accessible.
Additional Warnings for Products with a Power Cord
● Do not use a power cord that is damaged. This could cause fire or electric shock. Contact the
manufacturer for a replacement cord, if necessary.
● Only use a power cord which is appropriately rated and approved relevant to the country of use.
● When connecting to the mains supply, connect only to an earthed supply outlet which is installed
near the equipment and is easily accessible.
Additional Warning for Products with Power over Ethernet
(PoE) Functionality
● If the product is powered using Power over Ethernet, you must use an appropriately rated and
approved networking device, or the power injector identified for use with this product.
External Power Supplies
This product must only be used with an external power supply of the type and specification provided with
it. Replacement external power supplies can be obtained from the supplier of your Poly equipment.
PoE Products
Products that are designed to be connected to a Power Over Ethernet source must only be connected to
a IEEE 802.3 compliant power-over-ethernet (PoE) power source.
The power plug, wall socket combination acts as a disconnection device and must be accessible at all
times.
Power Cables
Only use the power cables that are supplied with this product, these are correctly rated for this product.
To Next Page
Loading...
Need help?
General
