Poly Edge B30

Home
PBXware
SERVERware
TELCOware
SIPmon
SIPProt
Desktop & Mobile
BRM
UADs
Appliances
EOL
From Bicom Systems Wiki
Contents
1 Introduction
■
2 Requirements
■
2.1 Identifying phone model
■
2.2 Phone firmware
■
2.3 DHCP server
■
2.4 PBXware version
■
3 Installation
■
3.1 Power adapter
■
3.2 Power over Ethernet (PoE)
■
3.3 Find the phone IP address
■
3.4 Reset to factory settings
■
4 Registering phone
■
4.1 Manual configuration
■
4.2 Auto Provisioning
■
4.3 Using TLS
■
5 Configure BLF
■
5.1 Extension Settings
■
6 Additional Configuration Template
■
Introduction

Poly Edge B30 Specifications

General

Brand	Poly
Model	Edge B30
Category	IP Phone
Language	English

Summary

Introduction

Requirements

Identifying Phone Model

Check the phone's back for exact model information to ensure correct setup and compatibility.

Phone Firmware

Verify the phone has the appropriate firmware version, checking via its IP address and web interface.

Installation

Power Adapter

Connect the phone's DC plug to the power adapter and an electrical outlet, and the Ethernet cable to the network.

Power Over Ethernet PoE

Power the phone using a PoE-compliant router or switch via the Ethernet cable.

Find Phone IP Address

Locate the phone's IP address by pressing the Home button and navigating to Product Information.

Reset To Factory Settings

Resetting the phone to factory defaults via its web administration interface for troubleshooting or initial setup.

Registering Phone

Manual Configuration

Configure phone settings manually, including UAD, extension creation, and phone registration.

UAD Settings

Enable and configure Universal Auto-Discovery (UAD) settings in PBXware for phone provisioning.

Creating Extension

Add new phone extensions in PBXware, specifying the model, location, and required fields.

Registering Phone Hostname IP Address

Register the Poly Edge B30 phone using Hostname or IP Address via the phone's web interface.

Auto Provisioning

UAD Settings Auto Provisioning

Configure UAD settings in PBXware for automatic phone provisioning via DHCP or Static IP.

Creating Extension Auto Provisioning

Create phone extensions in PBXware, specifying the model, location, and required fields.

Registering Phone TFTP HTTP HTTPS

Register phone using TFTP, HTTP, or HTTPS protocols for auto-provisioning.

Using TLS

Install Certificate

Install necessary certificates on the device for secure TLS communication.

Configure BLF

Extension Settings

Configure BLF (Busy Lamp Field) for Poly Edge B30 by editing extension settings.

Additional Configuration Template