Poly Edge B30 User Manual

install certificate to your device.
To install certificate, please do the following:
Open a new browser window and enter your device's IP address, e.g. http://192.168.1.22.
■
Enter username and password and press the Confirm button. NOTE: The factory default
■
login details are as follows: username is admin and password is admin.
Click the System Management
■
Click the Device Admin
■
Go to Platform CA 1 section.
■
Clear the DownloadURL default check box and enter the URL to your certificate.
■
Go to TLSPlatform Profile 1 section.
■
Clear the CACertList default check box and select Platform 1.
■
Click Submit button.
■
Click Reboot button.
■
You will have to wait some time for the device to reboot. If everything is done as described
above, you should have successfully installed certificate to your device.
Configure BLF
Extension Settings
This section describes how to configure BLF (Busy Lamp Field) for Poly Edge B30.
Log in to the PBXware's web administration interface.
Open a new browser window and enter the IP address in order to access the PBXware's web
■
administration login page. Example: http://192.168.1.10.
Log in to PBXware with the e-mail address and password.
■
Edit an Extension
On the Extensions page, click the Edit icon corresponding to the Extension.
■
Click Advanced Options.
■
Navigate down to the Auto Provisioning and Presence group of settings.
■
Make sure Auto Provisioning is set to Yes.
■
Make sure Presence is set to "Yes".
■
Click Save.
■
Click Enhanced Services.
■
Click the Directory / BLF List check box and click the Save button in order to enable this
■

Poly Edge B30 Specifications

General

Brand	Poly
Model	Edge B30
Category	IP Phone
Language	English