What to do if all zones open and Polyaire Zonemaster Unipoint touchpad display 'safety'?
If all zones are open and the touchpad displays 'safety', you should check the high and low limit settings. Also, check and replace the supply air sensor.
What to do if Polyaire Zonemaster Unipoint Control Systems dampers have no response when turning it on or off?
If the dampers aren't responding when you try to turn them on or off, start by checking the damper controller to ensure the LED is lit. Next, verify the damper address and inspect the cable connected to the damper controller.
What to do if Polyaire Control Systems touchpad has nothing shown on LCD?
If the touchpad LCD is blank, check the power supply first. Also, check the cable and plug connected to the touchpad.
What to do if some zones cannot be turned off in Polyaire Zonemaster Unipoint Control Systems?
If some zones can't be turned off, check if they are spill zones (with a lower address). Also, verify the spill setpoint.
How to fix abnormal touchpad display in Polyaire Control Systems?
To fix a touchpad display that isn't normal, first disconnect the battery. Then, reset the touchpad by turning the power supply off and on again. If the display returns to normal, plug the battery back in.
How to troubleshoot Polyaire Control Systems when the damper controller LED doesn't light up after powering on?
If the LED light on the damper controller doesn't light up after powering on, check the power supply. Also, check the cable to and from this damper controller, and the connection between the cables and the controller.
Procedure to enter and exit the system's setting mode using specific buttons on the touchpad.
Guide to calibrating the onboard room temperature sensor for accurate readings.
Setting the total number of on/off zones for system status and spill/bypass calculations.
Setting high and low limits for supply air temperature to ensure system safety.
Configuring the spill/bypass air setpoint for duct pressure relief.
Customizing names for each zone to improve identification and usability.
Procedure to test damper connection and functionality by cycling zones on/off.
General| Category | Control Systems |
|---|---|
| Brand | Polyaire |
| Model | Zonemaster Unipoint |
| Type | Zone Controller |
| Power Supply | 24VAC |
| Installation | Wired |
| Application | Residential and Commercial HVAC Systems |
To Next Page
