Position with respect to the project tempo (BPM). Values the same as above.
l – Finetune LFO, Sets the LFO rate for finetuning value. Values the same as above.
D – Overdrive, sets the amount of Overdrive effect. From 0% to 100%.
L – Low-pass, sets the cutoff amount of the Low-pass Filter. From 0% to 100%.
B – Band-pass, sets the cutoff amount of the Band-pass Filter. From 0% to 100%.
H – High-pass, sets the cutoff amount of the High-pass Filter. From 0% to 100%.
s – Delay, sets the amount of Delay send effect. From 0% to 100%.
t – Reverb, sets the amount of Reverb send effect. From 0% to 100%.
a – e – MIDI CC A -E, sends MIDI CC Value set to A-E in the Config. From 0 to 127.
f – MIDI program change, sends MIDI Program Change messages. From 0 to 127.
Performance mode FX list:
Volume (from -100 to 100),
Panning (from -100 to 100),
Tune (from -48 to 48),
Low-pass filter cutoff (from -100 to 100),
High-pass filter cutoff (from -100 to 100),
Band-pass filter cutoff (from -100 to 100),
Delay Fx send (from -100 to 100),
Reverb Fx send (from -100 to 100),
Sample position (from -100 to 100),
Sample end (from -100 to 100),
Sample playback Forward (>>>>>) and Reverse (<<<<<),
To Next Page
Loading...
