Page 3 of 20
March 2024
PJN3 SERIES
RECIRCULATING FLUSH
• When using air operated screw drivers or impact wrenches, be sure that the torque setting does not exceed 28 inch pounds.
• When using a battery-operated drill, set it to the lowest torque setting.
• Please follow the instructions in the order they are presented. It is suggested that you read through the entire assembly instructions
prior to proceeding with the assembly.
• All references to left, right, front and rear throughout the entire assembly instructions are as viewed from the front of the
restroom.
• All rivet holes drilled 13/64” dia.
• Use 1/4” disposable shim strips.
• The PJN3 Model restroom assembly will require two people.
• These instructions are for restrooms shipped unassembled. If you receive assembled units, please retain these instructions
for maintenance and repair purposes.
• We strongly suggest that these restrooms, as with all portable structures, be transported and handled with care. Dropping
the restroom when loading and unloading could cause damage to the door jamb and other components.
PRODUCT OVERVIEW
TOOLS REQUIRED FOR ASSEMBLY
Drill
Socket WrenchRivet Gun with
3/16” tip
13/64” Drill Bit Phillips Cross-head
Screwdriver
Marker
7/16” Socket
Awl
Slotted Screwdriver
To Next Page
Loading...