10. After programming all the values, press the
"SET" button to conrm the programmed
values and to return to the main screen. (After
approximately 10 seconds the programmed
values will be automatically conrmed and the
display will return to the main screen).
11. It is possible to press the “PROG” button
repeatedly to view the programs set.
12. The set programs can be freely modied at
any time by repeating the programming steps
(points 1 to 7).
To set a dierent program for each day, the
programming must be performed separately for each
day of the week, selecting the days one by one. (If
there are days for which it is intended to create the
same program, simply create the program only once,
because it can be easily applied to every other day
via the "COPY" button as described in section 4.2).
If not all six daily ranges are required, it is possible
to omit the adjustment of certain programs by
pressing the “DAY ” button during programming
on the unwanted program. The display shows this
process through lines (- - - -), which appear on the time
and temperature segments. The ignition omitted can
be restored or activated at any time by repeating the
programming steps (points 1 to 7) and pressing "DAY"
on the previously reset program.
4.2 "COPY" function
The "COPY" function is used to copy a one-day
program to another day or to dierent days.
• Press the “SET” button.
• Press the “COPY” button for approximately 5
secondsto activate the “COPY” function that appears
on the display; day 1 of the week (Monday) ashes
and it is possible to proceed to the copy operations.
• Press the buttons (-) or (+) to select the day from
which to copy the program.
To Next Page
Loading...