POLYPOOL PP1465 - Manual Temperature Adjustments; Changing Temperature for Next Ignition

5.
FACTORY VALUES COMBINED
WITH THE BUTTONS
(-) AND (+)
The temperature values 18°C and 22°C are assigned
to the buttons (-) and (+) in the factory, with which
it is possible to manually and temporarily modify
the program in operation (section 5.1).
These two factory values can be changed as follows:
Temperature button (-):press the button “SET”, hold
it down and then press the (-) button once and then,
using the (-) and/or (+),buttons, set the temperature
to be combined with the (-)button. After setting the
temperature, press the "SET" button again to conrm
the temperature value and to return to the main screen.
(After approximately 10 seconds the adjustment just
completed will be automatically conrmed and the
thermostat will return to the main screen).
Button temperature (+):press the “SET”, button,
hold it down and then press the (+) button once
and then, using the(-) and/or (+), buttons, set the
temperature to be combined with the (+) button.
After setting the temperature, press the "SET" button
again to conrm the temperature value and return to
the main screen. (After approximately 10 seconds
the adjustment just completed will be automatically
conrmed and the thermostat will return to the main
screen).
To operate the thermostat so that it diers temporarily
from the program set (for example during holidays or
at certain times of the day), it is possible to choose
from the following options:
5.1 Changing the temperature
until the next ignition program
It is possible to manually force the program into
operation by pressing the (-) or (+) buttons. On the