Polytec PSV 300 User Manual


  
                             
    
The PSV complies with the electrical safety class I. Electrical shock protectionThe PSV complies with the electrical safety class I. Electrical shock protection
is achieved by a is achieved by a fully metallic housing connected to protective ground.fully metallic housing connected to protective ground.
    to the followingto the following   when using thewhen using the
PSV:PSV:

The PSV controller and the workstation should only be The PSV controller and the workstation should only be connected viaconnected via
three pin mains cabthree pin mains cables to an AC mailes to an AC mains supply 50/ns supply 50/ 6060Hz with a groundeHz with a groundedd
protective conductor with a nominal voltage which corresponds to theprotective conductor with a nominal voltage which corresponds to the
voltage set on the voltage selector.voltage set on the voltage selector.
 The mains voltage input of the workstation can also be designed as a wideThe mains voltage input of the workstation can also be designed as a wide
range input like the junction box and therefore be connected to all mainsrange input like the junction box and therefore be connected to all mains
voltages with nominal values betwvoltages with nominal values between 100een 100 V and 240V and 240 VV..
 Defective mains fuses may only be replaced Defective mains fuses may only be replaced by fuses of the by fuses of the same kindsame kind
with their rating given on the back.with their rating given on the back.
 The PSV must not be used with open housing. As a general rule, beforeThe PSV must not be used with open housing. As a general rule, before
removing parts of the housing, the mains cable has to be unplugged.removing parts of the housing, the mains cable has to be unplugged.
 Air inlets and outlets must always be kept uncovered to ensure effectiveAir inlets and outlets must always be kept uncovered to ensure effective
cooling. If the cooling fan cooling. If the cooling fan stops working, the PSV is to be switched offstops working, the PSV is to be switched off
immediately.immediately.

Polytec PSV 300 Specifications

General

Brand	Polytec
Model	PSV 300
Category	Measuring Instruments
Language	English