Need help?Do you have a question about the Polytec OFV-511 and is the answer not in the manual?
General| Velocity range | 0.02 µm/s to 10 m/s |
|---|---|
| Type | Vibrometer |
| Fiber length | Standard 2 m, optional up to 10 m |
| Output Voltage | ±10 V |
| Laser Power | 1 mW |
Detailed safety precautions for handling the laser beam and preventing eye injury.
Safety precautions related to electrical connections and usage.
Description of the front and back panel controls of the controller and sensor heads.
Step-by-step guide for installing and testing the vibrometer with OFV-303/-353 sensor heads.
Steps for installing and testing the vibrometer with OFV-511/-512 sensor heads.
Steps for preparing and starting the vibrometer for measurement with OFV-303/-353.
Steps for preparing and starting the vibrometer with OFV-511/-512.
Parameters and considerations for setting up velocity measurements.
Guidance on selecting measurement ranges for displacement signals.
Procedures for powering the controller and sensor head on and off.
Explanation of the beam shutter function and emission indicators.
Methods for manually and remotely focusing the laser beam.
Basic tests to perform when the vibrometer is not functioning properly.
Troubleshooting steps for when the laser beam is not emitted.
Troubleshooting steps for when there is no measurement signal despite the laser beam.
A checklist to help diagnose faults for specific controller/sensor head combinations.
A checklist to help diagnose faults for specific controller/sensor head combinations.
Explanation of the velocity decoding operating principle.
Characteristics and features of the OVD-01 and OVD-02 velocity decoders.
Explanation of direct counting and interpolation modes for displacement measurement.
Explanation of direct counting and interpolation modes for displacement measurement.
To Next Page
