6DIHW\ ,QIRUPDWLRQ
(OHFWULFDO6DIHW\
The vibrometer complies with the electrical safety class I. Electrical shock
protection is achieved by a fully metallic housing connected to protective
ground. Please pay attention to the following safety precautions when using
the vibrometer:
The vibrometer should only be connected via a three pin mains cable to
an AC mains supply 50/60Hz with a grounded protective conductor with a
nominal voltage which corresponds to the voltage set on the voltage
selector.
Defective mains fuses may only be replaced by fuses of the same kind
with their rating given on the back of the controller.
None of the equipment may be used with open housing. As a general rule,
before removing parts of the housing, the mains cable has to be
unplugged.
Air inlets and outlets must always be kept uncovered to ensure effective
cooling. If the cooling fan stops working, the vibrometer is to be switched
off immediately.
Figure 1.6: Position of the laser warning labels on the sensor head OFV-511/-512 in non-EC
countries
3
1
SIGNAL
PRO CESSO R
ACHTUNG!
Bitte vor dem Transport
die Transportsicherung betätigen
CAUTION!
Please secure transport m echanism
b e fo re s h ip m e n t
MEASUREM ENT
TRAN SPO R T
To Next Page
Loading...
Need help?
General
