Need help?Do you have a question about the Polytec PDV-100 and is the answer not in the manual?
General| Category | Vibration Measurement |
|---|---|
| Measurement Principle | Laser Doppler Effect |
| Laser Class | 2 |
| Laser Wavelength | 633 nm |
| Stand-off Distance | Up to 30 m (depending on optics) |
| Output Signals | Velocity |
| Interfaces | Ethernet |
| Storage Temperature | -20°C to +60°C |
Provides essential safety guidelines for operating the instrument.
Details safety precautions related to the laser system.
Covers electrical safety requirements and precautions for the PDV.
Outlines safety measures for using and charging batteries.
Describes the intended uses and applications of the PDV-100.
Explains the heterodyne interferometer principle behind the PDV.
Guides users through unboxing and checking the instrument.
Lists requirements for operation and general maintenance.
Identifies and describes the device's control elements on the top view.
Details the control elements located on the rear of the PDV.
Details the control elements and mounting points on the bottom of the PDV.
Provides instructions for physically installing and assembling the PDV.
Step-by-step guides for mounting the PDV on specific tripods.
Instructions for connecting the PDV to power sources.
Steps to prepare for the initial functional check of the PDV.
Procedures for powering on the PDV and activating the laser.
Steps for testing the PDV's optics, electronics, and output signals.
Outlines the initial steps to prepare for making measurements.
Explains how to choose the appropriate velocity measurement range.
Details how to configure the low pass filter settings.
Explains how to set up the high pass filter for noise reduction.
Guidance on determining the best distance for measurements.
Provides formulas and values for optimal stand-off distances.
Instructions for powering the PDV on and off using different sources.
Describes how to use the beam shutter to block the laser.
Steps for adjusting the focus of the laser beam.
Explains how to use the signal level display for focus optimization.
Guides on how to lock the focus using the clamping screw.
Overview of how to navigate and set parameters on the PDV display.
Describes the structure and flow of the PDV's menu system.
Instructions for accessing and using the service mode.
Explains the overrange indicator on the display and its meaning.
Describes the battery level indicator and its interpretation.
Details the available analog and digital signal outputs.
Troubleshooting steps when the laser beam is not emitted.
Troubleshooting steps when no measurement signal is detected.
Solutions for a stuck focusing ring.
Lists the safety and compliance standards applied to the PDV.
Provides general specifications for the PDV-100, including power and ambient conditions.
Specifies operating and storage environmental conditions.
Details the housing specifications like protection rating and dimensions.
Information regarding recommended calibration intervals.
Lists detailed measurement performance characteristics.
Details analog and digital signal output characteristics.
Details low pass and high pass filter specifications and response.
Provides specifications related to the laser and optics.
Provides physical dimensions and diagrams of the PDV-100.
A table showing visibility maxima at different stand-off distances.
Specifications for the PDV-AC power supply unit.
Details the specifications and dimensions of the mounting plate.
Specifications for the PDV-CH battery charger.
Electrical and housing specifications for the PDV-LI battery.
Specifications for the PDV-BS carrier bag.
Connection data for the motor vehicle supply cable.
Details controls, connections, and charging procedures for the battery charger.
Instructions for operating the PDV using the battery.
How to operate the PDV using mains connection via the battery charger.
Information on the proper disposal of batteries.
Explains the principle of optical interference in measurement.
Describes the relationship between phase difference and path difference.
Defines and explains heterodyne interferometers used in the device.
Official statement confirming compliance with directives and standards.
To Next Page
