A-7
A Optional Accessories
A.1.4 Mains Operation
You can also operate the PDV using the mains connection with the aid of the
plug-in power supply - even if the battery is connected. As soon as you plug
the power supply connected to the battery charger into a mains earthedl
socket and press the rocker switch in the direction of the Laser L
ED
the power
supply for the PDV is automaticlly changed over to mains operation. In doing
so, no power is sourced from the battery, but it does not get charged either.
The display of the PDV then remains lit up constantly, the power saving mode
is deactivated.
A.1.5 Battery Return
The consumer is legally obliged to pass back batteries after use, e.g. at public
collecting points or wherever batteries of this type are being sold.
NOTE!
Batteries must not be disposed in domestic waste!
A.2 Motor Vehicle Supply Cable PDV-DC
You use the motor vehicle supply cable PDV-DC, to operate the PDV or the
battery charger PDV-CH from a 12V on-bord plug socket or a motor vehicle
cigarette lighter. To do so, connect the 4-pin circular jack of the motor vehicle
supply cable to the 4-pin circular connector 12V on the back of the PDV or on
the top of the battery charger. Then plug the connecting plug into the 12V on-
board plug socket or, using the red adapter into the motor vehicle cigarette
lighter.
CAUTION!
Danger from mishandling ! We do not recommend operating the PDV while the engine is
running.
NOTE!
Use the red adapter for operation from a moter vehicle cigarette lighter.
To Next Page
Loading...
Need help?
General
