For mounting the scanning head at the telescope drive, you proceed asFor mounting the scanning head at the telescope drive, you proceed as
follows:follows:
1.1. Fix thFix the telese telescope drcope drive at the mive at the measueasuremenrement locatt location usion using the 6 scring the 6 screws ofews of
the assembly kit (refer tothe assembly kit (refer tofi
figugurere A.A.55, picture 1)., picture 1).
2.2. If applIf applicablicable, unde, undo the quico the quick releak release hexase hexagonagonal plate or tl plate or the mounhe mountingting
plate for the plate for the pan-tilt head from the scanning head.pan-tilt head from the scanning head.
3.3. AttAttach the adach the adapter plapter plate on the unate on the undersderside of the scide of the scannianning head as shng head as shownown
ininfi
figugurere A.A.55, picture 2., picture 2.
4.4. Hang up tHang up the scanhe scanning hening head witad with the adah the adapter plpter plate aboate above at thve at the telese telescopecope
drive (refer todrive (refer tofi
figugurere A.A.55, picture 3)., picture 3).
5.5. SecuSecure the scre the scannianning head by fing head by fixing thxing the adapte adapter plater plate to the tele to the telescoescopepe
drive using 2 Allen screws (refer todrive using 2 Allen screws (refer tofi
figugurere A.A.55, picture 4)., picture 4).
For the electrical connection of the test stand, you proceed as follows:For the electrical connection of the test stand, you proceed as follows:
1.1. ConneConnect the cact the cable of thble of the telese telescope dcope drive to thrive to the motoe motor conner connectioctionn of theof the
drive control indrive control infi
figugurere A.A.66..
2.2. Plug Plug the the hand hand set set cable cable into into the the Sub-Sub-D jD jackack ininfigfigururee A.A.66..
Figure A.5: Mounting the scanning head to the telescope driveFigure A.5: Mounting the scanning head to the telescope drive
To Next Page
Loading...
