11
8. Finishing
When the foil tube is long enough to fully cover the ends of
the last bales, wrap some extra rounds at the end of the foil
tube to give a strong end. Cut off the foil at a suitable
length.
Set up the machine to run by itself so that it runs as free of
the stack as possible. Move the baler a short distance away from the stack by dragging with a
tractor using the hitch (see illustration).
The bottom foil is removed so that the wheels can be mounted. If you are not going to drive on
a road you can leave the bottom foil on, as there are 2 positions for the transport wheel.
Please remember: The foil rolls must not lie on the horizontal part up top during on-road
driving. If you have a hydraulic hoist, remember to lower the tower before entering the road.
If hydraulic lift is included, the tower must be lowered before transport on roads.
9. Change of foil roller
Check that the foil roll bracket is positioned so that it can be reached when the guard in the rear
end is open.
Push the emergency stop button and stop the motor.
Open the guard in the rear end.
Change the foil roll and close the guard.
Start the motor and switch on the emergency stop.
To Next Page
Loading...