Pontiac 2002 Aztek User Manual

2-71
To remove the sunroof stop, do the following:
1. Remove the tool located in the bag in the glovebox
labeled “tool kit
-acsry.”
2. Place the tool on the screw located in the side rail
assembly in front of the front crossrail.
3. Remove the screw.
4. Repeat for the other side.
5. Put the tool and the screws back in the plastic bag in
the glove box.
Lift the release levers on each side to unlock the
crossrails. Slide the crossrails forward or backward, as
needed, to accommodate loads of various sizes.
After repositioning the crossrails, engage the release
lever. This will lock the crossrails in place.
NOTICE:
Do not open the sunroof if the crossrails are not
in the full rear position. This could cause damage
to the sunroof glass panel and/or the crossrails.
Use the four tie-down loops
in each of the side rails to
help secure large loads.
To replace the sunroof stop, do the following:
1. Put the crossrails in the full rear position.
2. Put the screws back into each side rail assembly.
Make sure the screws are in the first hole in front of
the crossrail.

Pontiac 2002 Aztek Specifications

General

Brand	Pontiac
Model	2002 Aztek
Category	Automobile
Language	English