EasyManua.ls Logo

Pontiac AZTEK 2005 - Sliding Rear Convenience Tray; Adjusting the Roof Rack Crossbows

Pontiac AZTEK 2005
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
Sliding Rear Convenience Tray
(if equipped)
or by pressing REAR on the Remote
Keyless Entry System key fob
transmitter.
When the liftgate is
opened, reach inside
the tailgate to lift the
handle and open the
tailgate. When closing
them, always close the
tailgate first. Closing
the liftgate first can result in damage or
breakage.
See Section 2 of your Owner Manual.
This feature makes it easier to load,
organize and remove items from the
rear of your vehicle. To use the tray:
Push the release lever located in
front of the handle of the tray to
release it from the floor assembly.
Pull the tray toward you until you
hear a click, indicating the tray is in
the extended locked position.
Push the release lever again and roll
the tray back into the vehicle until
hearing a click, indicating the tray’s
locked position.
See Section 2 of your Owner Manual.
Note: Under normal driving conditions,
the tray’s latching mechanism provides
sufficient retention. However, the tray’s
tether strap provides added safety in
the event of a collision. The strap
does not affect the tray’s ability to be
maneuvered into the vehicle or over the
tailgate.
Adjusting the Roof Rack
Crossbows (if equipped)
If your vehicle is equipped with a sun-
roof, you will need to first remove the
sunroof stop in order to adjust the roof
rack crossbows. To remove the sunroof
stop, use the special tool located in the
glove box, and then:
Place the tool on the screw located in
the side rail assembly in front of the
crossbow.
Remove the screw and repeat for the
other side.
Put the tools and screw back in the
plastic bag in the glove box.
Adjusting the Rails:
Lift the release lever on each side of
the crossbow (unlocked position).
Slide the crossbows forward or
backward to accommodate various
size loads as needed.
Engage the release lever to lock the
crossbows in place.
Replacing the Sunroof Stop:
Place the rear crossbow in the fully
rear position.
Move the front crossbow rearward
of the sunroof stop screw hole. Put
the screws back into each siderail
assembly.
See Section 2 of your Owner Manual.
Important: Do not open the sunroof (if
equipped) if the crossbows are not in
the fully rear position, as damage could
result to the sunroof glass panel and/or
crossbows.

Related product manuals