Getting to Know Your Aztek
14
Rear Door Security Locks
To prevent rear seat
passengers from
opening the rear doors
from the inside:
• Open a rear
door and locate
the lock on the
inside of the door.
• Slide the lever to the Lock position.
Repeat the process for the other rear
door. To disable this feature, reverse the
process.
See Section 2 of your Owner Manual.
Rear Center Shoulder Belt
The rear seat’s
center shoulder
belt stows over-
head. To use it,
remove it from
its stowage
location, pull it
down and
attach it to the
belt buckle,
inserting its
knob through
the buckle key-
hole. This com-
pletes the
three-point belt
routing. The
elastic strap
stored under the driver-side head
restraint connects with a sliding loop on
the belt. Hook the elastic strap to the
loop, as shown, to lower the routing
of the belt as needed for maximum
comfort.
See Section 1 of your Owner Manual.
LATCH System
Your vehicle is equipped with the Lower
Anchorages and Top Tethers for
CHildren (LATCH) system, which
requires a special,
compatible Child
Restraint Seat in
order to use the
LATCH system.
(See your Owner
Manual for full
instructions for
securing conven-
tional and
LATCH-compatible
child restraints in your Aztek.)
LATCH locations are located below the
contrasting fabric dots on second-row
split-bench seats (shown). There are
two LATCH locations provided in the
second row (both outboard seating
positions).
See Section 1 of your Owner Manual.
To Next Page
Loading...
