Pontiac AZTEK 2005 - Page 5

5
Personalizing the DIC
Your DIC can be programmed to recall
personalized settings for up to two driv-
ers. The settings will be automatically
recalled when using your Remote
Keyless Entry System transmitter
(key fob). After pressing the LOCK but-
ton on the key fob (and with the ignition
On), the DIC will display the driver num-
ber and then recall the features that
were programmed to correspond to that
key fob. If you unlock your vehicle using
the key instead of your key fob, the DIC
will recall the settings from the last key
fob used.
To program features:
• Enter Programming Mode by turning
the ignition key to ON with the
transmission in Park.
• Repeatedly press and release the
MODE button until “PRESS SET TO
BEGIN PERSONALIZATION” is
displayed.
• Press the SET button. On the display,
“TO SELECT DRIVER PRESS
REMOTE LOCK” appears.
• Press the LOCK button on your key
fob transmitter. This identifies you
with the key fob signal and, if key fob
transmitter #1 is being used, identi-
fies the transmitter number by dis-
playing “PERSONALIZATION FOR
DRIVER 1.” If key fob transmitter #2
is being used, the DIC identifies the
transmitter number by displaying
“PERSONALIZATION FOR
DRIVER 2.”
• The PROGRAM MODE message in
the display center indicates that it is
ready to begin programming.
Follow the DIC instructions on the
display to personalize each of the
following:
• Headlamp exit delay
• Interior lighting delay
• Interior lighting on
• Auto door lock/unlock
• Delayed locking
• Remote door unlock
• Lock/unlock feedback
Exiting Programming Mode
When you have reached the end of the
entire personalization list by pressing
the MODE button, the “PERSONALIZA-
TION SELECTION DONE” message
appears on the DIC display, followed by
“PRESS SET TO EXIT MODE TO CON-
TINUE.” To go back through the list
again, press MODE. If you are satisfied
with your settings, press SET. You can
also exit programming mode by:
• Shifting the vehicle out of Park (P)
• Turning the ignition key out of the ON
position
• Not programming any commands for
one minute, while in the programming
mode
See Section 3 of your Owner Manual.
Note: If equipped with DIC, when the
outside temperature is below 38°F, the
display will flash between “ICE” and the
current temperature for two minutes
after starting the vehicle. This safety
feature warns of possible icy conditions
and that caution should be taken when
driving.