PROBLEMPROBLEM CAUSECAUSE REMEDYREMEDY
Priming CellPriming Cell Requires water across the Requires water across the
Cell to complete the circuit Cell to complete the circuit
before the chlorinator before the chlorinator
will display OK and start will display OK and start
chlorinationchlorination
Make sure that the pump is primed Make sure that the pump is primed
with water and operating correctly with water and operating correctly
Make sure any Valves are in the open Make sure any Valves are in the open
position and water is owing through position and water is owing through
the CELLthe CELL
Chlorine Chlorine
output will not output will not
reach 100%reach 100%
Salt level is not high enoughSalt level is not high enough Salt level should be as per Salt level should be as per
recommendations on page 9 of this recommendations on page 9 of this
handbookhandbook
Water temperature is lowWater temperature is low Winter water temperatures can get Winter water temperatures can get
very low, for every 1C below 28C the very low, for every 1C below 28C the
chlorinator output can drop by 2%chlorinator output can drop by 2%
Cell has too much calcium Cell has too much calcium
deposit on platesdeposit on plates
Clean the cell in a 1/91tr ratio of Clean the cell in a 1/91tr ratio of
Hydrochloric acid & water or a Hydrochloric acid & water or a
cleaning solution available from any cleaning solution available from any
pool storepool store
Cell could be at end of lifeCell could be at end of life If salt conditions are correct and the If salt conditions are correct and the
cell won’t achieve its full output you cell won’t achieve its full output you
may require a new Cellmay require a new Cell
Cell LifeCell Life How long will my Cell lastHow long will my Cell last At 4hr reversals the cell can last At 4hr reversals the cell can last
approx 13,000hrs+ and at 12hr approx 13,000hrs+ and at 12hr
reversals approx 18,000hrs+reversals approx 18,000hrs+
No Chlorine No Chlorine
measured in measured in
thethe
PH is far too High waterPH is far too High water Add Hydrochloric acid to reduce the Add Hydrochloric acid to reduce the
PH between 7.2-7.8ppmPH between 7.2-7.8ppm
No Stabiliser in the water No Stabiliser in the water Add Cyanuric acid (Stabiliser) until Add Cyanuric acid (Stabiliser) until
you have 20-S0ppmyou have 20-S0ppm
Chlorinator isn’t operating Chlorinator isn’t operating
long enough or at high long enough or at high
enough outputenough output
Increase operating hours or Increase operating hours or
percentage outputpercentage output
Troubleshooting
12
To Next Page
Loading...
