PROBLEMPROBLEM CAUSECAUSE REMEDYREMEDY
Calcium build on Cell
is high
Cell cleaning time is set
too high
Enter the cell cleaning function
in the menu and reduce the
time between cleaning cycles
Salt measurement is
not correct
Too much calcium on the
cell when measuring
Clean the cell in a 1/91tr ratio
of Hydrochloric acid & water
a cleaning solution available
from any pool store
Salt measurement
accuracy
A 10% accuracy is all that can
be achieved without going
to very expensive probes &
solutions for calibration
Salt measurement says
cell at end of life
Salt cell is nearing the
end of its life
Only replace when cell
has completely failed, salt
measurements will continue to
be more inaccurate the longer
it is used past 10,000hrs,
measurements should then be
taken ONLY by your local pool
store or service agent until a
new cell is installed
My pump is always ON The Pump may have
been connected to
the mains before the
chlorinator
Make sure the pump is
plugged into the 240V socket
on the chlorinator
The chlorinator is in
the ON mode and will
operate 24/7
Make sure the chlorinator
MODE is set to TIMER
My Display doesn’t
show the temperature
Dirty connection Remove the cell plug/cable
from the chlorinator power
module, apply some INOX,
WD40 or Vaseline to the
contacts attached to the cable
and re-install several times to
help clean the contacts
High Salt Salt level is above
7000ppm
Backwash water from the pool
and re-ll to reduce the salt
level to 7000ppm or below
13
To Next Page
Loading...
