PROBLEMPROBLEM CAUSECAUSE REMEDYREMEDY
Chlorinator won’t
go above 80% and
displays high salt
The chlorinator has a
protection feature that
will limit your output
to 80% when your salt
level gets too far above
7000mg/L
Discharge water from the pool
and re-ll to reduce the salt
level to 6000mg/L or below
Water/Condensation on
screen
Small amounts of
moisture can sometimes
be absorbed during the
manufacturing process
on the inner surface of
the plastic
Allow to operate and the
moisture will be expelled from
the chlorinator, normally within
24hrs
Error Code ‘Terr’
(Temperature Error)
Multi way connector dirty
or loose connection
Disconnect and Reconnect
multi way plug under power
pack
Sensor failure at Cell Return for repair
5 Volt Regulator failure on
Main Pcb
Return for repair
Error Code ‘Cell EOL’
(END OF LIFE)
Cell above 10,000hrs
usage Cell is nearing the
end of it’s useful life
Once the Cell can no-longer
achieve 100% for the desired
salt level a new cell will be
required
Also see CELL LIFE on Page 12
Pump Fail No Water present at Cell
sensor
Check pump can supply pool
water
(When activated pump
is locked out for 30min,
to bypass select
another Mode or reset
power at 240V wall
switch)
Pump may be stopping
intermittently, faulty
pump or overheating
Check pump operation
14
To Next Page
Loading...
