Minor Repairs 341
Wheel change
1. Remove the top wheel bolt with the wheel bolt
wrench from the tool kit.
Screwing in assembly aid
2. Remove assembly aid from the tool kit and
screw in instead of the wheel bolt.
3. Remove the remaining wheel bolts.
Please observe the chapter “WHEEL BOLTS”
on Page 331.
4. Change wheel.
5. Insert wheel bolts and tighten by hand.
Remove assembly aid and screw in remaining
wheel bolt.
Initially tighten bolts in diagonally opposite
sequence so that the wheel is centered.
6. Inflate the tire if necessary.
Please observe the chapter “TIRE PRESSU-
RES, COLD” on Page 406.
In vehicles with tire pressure monitoring:
Please observe the chapter “SETTING THE
TIRE TYPE AND SIZE” on Page 157.
7. Lower car and remove jack.
8. Tighten wheel bolts in diagonally opposite
sequence.
Tire Pressure Monitoring:
The settings on the multi-purpose display must be
updated after a wheel change.
Please observe the chapter “SETTING TIRE PRES-
SURE MONITORING” on Page 155.
Maintenance Note
f Immediately after changing a wheel, use
a torque wrench to check the prescribed
tightening torque of the wheel bolts
(118 ftlb./160 Nm).
To Next Page
Loading...
Need help?
General
