Porter-Cable 630 - Troubleshooting and Service Information; Service, Lubrication, and Brush Inspection

grime resulting from working green or sappy wood. All plastic parts
should be cleaned with soft damp cloth. NEVER use solvents to clean
plastic parts. They could possibly dissolve or otherwise damage the
material.
FAILURE TO START
Should your tool fail to start, check to make sure the prongs on the
cord plug are making good contact in the outlet. Also, check for
blown fuses or open circuit breakers in the line.
LUBRICATION
This tool has been lubricated with a sufficient amount of high grade
lubricant for the life of the unit under normal operating conditions.
No further lubricant is necessary.
BRUSH INSPECTION
At approximately 100 hours of use, take or send your tool to your
nearest Authorized Porter-Cable Service Station to be thoroughly
cleaned and inspected; worn parts replaced, when necessary; re¬
lubricated with fresh lubricant, if required; reassembled with new
brushes; and performance tested.
Any loss of power before the above maintenance check may indicate
the need for immediate servicing of your tool. DO NOT CONTINUE
TO OPERATETOOL UNDER THIS CONDITION. If proper operating
voltage is present, return your tool to the Service Station for
immediate service.
SERVICE AND REPAIRS
All quality tools will eventually require servicing or replacement of
parts due to wear from normal use. These operations, including
brush inspection and replacement, should ONLY be performed by
either an AUTHORIZED PORTER-CABLE SERVICE STATION or a
PORTER-CABLE SERVICE CENTER. All repairs made by these
agencies are fully guaranteed against defective material and
workmanship. We can not guarantee repairs made or attempted by
anyone other than these agencies.
Should you have any questions about your tool, feel free to write us at
any time. In any communications, please give all information shown
on the nameplate of your tool (model number, type, serial number,
etc.).
ACCESSORIES
The testing of this tool has been accomplished with the following
accessories. For safest operation, it is recommended that only these
accessories be used with this product.
WARNING - Since accessories other than those listed have not been
tested with this product, use of such accessories could be hazardous.
13