Do you have a question about the Porter-Cable FR350 and is the answer not in the manual?
Type | Framing Nailer |
---|---|
Nail Length | 2 to 3.5 inches |
Magazine Capacity | 60 nails |
Operating Pressure | 70 to 120 PSI |
Weight | 7.3 lbs |
Power Source | Pneumatic |
Length | 13.5 inches |
Width | 4.5 inches |
Nail Diameter | 0.113 to 0.131 inches |
Fastener Type | Clipped Head or Offset Round Head |
Explains DANGER, WARNING, and CAUTION symbols and their implications for hazard levels.
Key warnings and advice for safe operation and understanding the manual to prevent injury.
Emphasizes reading the manual and understanding hazards to prevent injury.
Details requirements for safety glasses and ear protection for all personnel.
Covers trigger discipline, tool pointing, and safe gas usage.
Specifies the need for clean, dry, regulated compressed air at correct pressure levels.
Covers safe connection to air supply, fastener loading, and avoiding accidental firing.
Details safe practices like avoiding horseplay, wearing hard hats, and preventing unintentional firing.
Addresses safe fastener driving angles, depth, and avoiding ricochets.
Outlines employer's duty to enforce safety warnings and manual instructions.
Details the pneumatic framing nailer's design, capacity, and fastener requirements.
Specifies air pressure, filtration, and oiling requirements for optimal tool performance.
Guides on connecting air supply, loading fasteners, and adjusting exhaust deflector.
Explains the 'Single Sequential Actuation' and 'Contact Actuation' firing modes.
Details how to adjust fastener depth and the use of the rubber nose cushion.
Step-by-step instructions for safely removing jammed fasteners from the nailer.
Procedures for cleaning, inspecting trigger/safety, and keeping screws tight.
Identifies common problems like air leaks and jamming, with corresponding solutions.
Details the warranty coverage, exclusions, and limitations for the tool.
Provides contact information and locations for Porter-Cable/Delta service centers in the US and Canada.