EasyManua.ls Logo

Porter-Cable FR350B - User Manual

Porter-Cable FR350B
51 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1 - ENG
FR350B
ROUND HEAD
FRAMING NAILER
Cloueuse de charpente à
clous à tête ronde
Clavadora para
estructuras con
cabezal redondo
www.portercable.com
INSTRUCTIVO DE OPERACIÓN, CENTROS
DE SERVICIO Y PÓLIZA DE GARANTÍA.
LÉASE ESTE INSTRUCTIVO
ANTES DE USAR EL PRODUCTO.
Française: Page 17
Español: Página 34
Instruction manual
Manuel d'instructions
Manual de'instrucciones
9R195763RA

Table of Contents

Questions and Answers

  • D
    Destiny KellyAug 6, 2025
    Why does my Porter-Cable Nail Gun jam so frequently?
    • L
      Laura FisherAug 6, 2025
      Your Porter-Cable Nail Gun might be jamming frequently due to several reasons. First, ensure you are using the correct fasteners of the appropriate size and 22° collation angle. Damaged fasteners or a bent collation wire can also cause jams, so replace them with undamaged ones. Check if the canister or nose screws are loose and tighten them if necessary. A dirty canister can also lead to jams, so clean the magazine. Lastly, a worn or damaged driver tip could be the culprit, in which case you should install a Driver Maintenance Kit.
  • C
    Chelsea WagnerAug 14, 2025
    What to do if my Porter-Cable Nail Gun operates sluggishly?
    • G
      Gregory RamirezAug 14, 2025
      If your Porter-Cable Nail Gun is operating sluggishly or not working at all, there are a few things to check. Ensure that the air supply is adequate. Insufficient lubrication can also cause this issue, so put 5 to 7 drops of oil into the air inlet. Finally, inspect the o-rings or seals for wear or damage; if found, install an Overhaul Kit.
  • G
    Glenn KellyAug 21, 2025
    How to fix air leak in Porter-Cable Nail Gun near the trigger?
    • B
      Brian BaileyAug 21, 2025
      If you notice an air leak near the top of your Porter-Cable Nail Gun or in the trigger area, it could be due to loose screws. Make sure to tighten them. Another possible cause is worn or damaged o-rings or seals. If that's the case, you'll need to install an Overhaul Kit.
  • C
    christineallenAug 28, 2025
    What causes air leak near the bottom of Porter-Cable Nail Gun?
    • M
      Melissa CampbellAug 28, 2025
      An air leak near the bottom of your Porter-Cable Nail Gun can be caused by loose screws; ensure they are tightened. It may also be due to worn or damaged o-rings or the bumper. In this case, consider installing an Overhaul Kit.

Summary

Operation, Service Centers, and Warranty Information

Important Safety Instructions for Pneumatic Tools

Definitions - Safety Guidelines

Defines signal words (Danger, Warning, Caution, Notice) used in the manual for safety.

Nail Specifications

Tool Parts

Assembly

Trigger

Explains the selectable trigger modes (sequential, bump) and lock button for safety.

Air Fitting

Details the air inlet size and required quick connector couplings for tool operation.

Operation

Preparing the Tool

Outlines essential checks, lubrication, and air pressure settings before operating the nailer.

Loading the Tool

Provides step-by-step instructions on how to load fasteners into the nailer magazine correctly.

Actuating Tool

Single Sequential Actuation Trigger

Describes the single sequential trigger mode for precise fastener placement and its operation.

Contact Actuation Trigger

Explains the contact actuation trigger mode for rapid fastening and its two methods.

Adjusting Depth

Directional Exhaust Deflector

No-Mar Pad

Clearing a Jammed Nail

Cold Weather Operation

Hot Weather Operation

Maintenance

Cleaning

Instructions on how to clean the tool parts using water and mild soap, avoiding harsh chemicals.

Repairs

Information on how to get assistance for tool repairs and finding service centers.

Replacement Parts

Guidance on ordering identical replacement parts and where to find them.

Service and Repairs

Details on tool servicing, factory service centers, and warranty repair information.

Accessories

Three Year Limited Warranty

1 Year Free Service

Covers free maintenance and worn part replacement for the first year of ownership.

90 Day Money Back Guarantee

Offers a full refund within 90 days if the customer is not completely satisfied with the tool.

Troubleshooting Guide

Tool Specifications

Lists detailed technical specifications for the FR350B nailer, including dimensions and pressure.

Porter-Cable FR350B Specifications

General IconGeneral
TypeFraming Nailer
Power SourcePneumatic
Operating Pressure70-120 PSI
Nail TypeFraming nails
Nail Size2 to 3-1/2 inches
Nail Gauge21
Magazine Angle21-degree

Related product manuals