Porter-Cable NS100 User Manual

Wear ANSI Z87.1 compliant safety glasses with side shields.

Use ear protection to prevent hearing loss.

Use clean, dry, regulated air at 70-120 PSI.

Do not exceed 200 PSI (13.7 BAR) for tool connection.

Use air hose rated for 150 PSI or 150% of system pressure.

Never use oxygen, CO2, or combustible gases for power.

Connect tool with a coupling that releases all pressure when disconnected.

Disconnect tool from air supply before maintenance or moving.

Do not use tools with leaks, missing/damaged parts, or safety issues.

Ensure safety, trigger, and springs are functional and not modified.

Ensure the safety warning label is present, legible, and intact.

Use only Porter-Cable recommended parts, fasteners, and accessories.

Connect tool to air supply before loading fasteners to prevent accidental firing.

Always assume tool contains fasteners; keep pointed safely away.

Do not load fasteners with trigger or safety depressed.

Keep finger off trigger when not driving; never carry with finger on trigger.

Maintain proper footing and balance at all times when using the tool.

Fire fasteners into the work surface only, not hard materials.

Grip tool firmly to maintain control while allowing tool to recoil.

Do not drive fasteners on top of others or at steep angles.

Avoid driving fasteners near workpiece edges to prevent splitting.

Keep hands and body parts away from the illustrated firing area.

Introduction to the Porter-Cable Model NS100 narrow crown stapler.

Details requirements for clean, dry, regulated compressed air supply.

Steps to connect and prepare the tool for operation.

Instructions on how to use the stapler for fastener placement and firing.

Procedure for safely removing jammed fasteners from the tool.

Daily procedures for cleaning and inspecting the tool for wear and damage.

Information on obtaining service and repairs from authorized centers.

Identifies common problems and their solutions.