What to do if Porter-Cable PCXB515BG wheel vibrates?
If your Porter-Cable Grinder wheel vibrates or shakes, it could be due to the grinding wheel not being properly fixed. Make sure to adjust the grinding wheel correctly. If the issue continues, you should contact a Porter-Cable Service Center or Authorized Service Station for assistance.
Why won't my Porter-Cable Grinder motor run?
There are several potential reasons why your Porter-Cable Grinder's motor might not be running. First, ensure the grinder is properly plugged into a functioning power outlet. Next, verify that the power switch is in the ON position. If the issue persists, there may be a cut or abraded motor cord, a faulty plug, or a faulty motor. In any of these cases, you should contact a Porter-Cable Service Center or an Authorized Service Station for repair or replacement. Lastly, check if the fuse on the circuit has blown. If so, reset it, and consider that there might be too many machines running on the same line.
Explains warning symbols and defines hazard levels like Danger, Warning, Caution, and Notice.
Covers general safety instructions, keeping work area clean, and preparation before use.
Emphasizes wearing safety goggles, appropriate apparel, and disconnect procedures.
Instructions on wheel guards, grinding wheel use, and avoiding physical contact.
Guidelines on electrical shock prevention and ensuring the switch operates correctly.
Details power requirements, circuit protection, grounding, and plug connection safety.
Provides specifications for selecting and using extension cords to ensure safety and performance.
General| Type | Bench Grinder |
|---|---|
| Voltage | 120V |
| No Load Speed | 3450 RPM |
| Wheel Diameter | 5 inches |
| Arbor Size | 1/2 in |
| Amperage | 2.1 A |
| Wheel Arbor | 1/2 in |
To Next Page
