POSIFLEX CD-3600 - Table of Contents

To Next Page

To Previous Page

Contents

INTRODUCTION .................................................................................................... - 1 -

1. GENERAL OPTIONS .......................................................................................... - 5 -

1.1. Restore to Factory Default Settings ............................................................... - 5 -

1.2. Switch User Interface and Reset to Default Settings ..................................... - 6 -

1.3. Check Firmware Version ............................................................................... - 6 -

1.4. Enhance Barcode Scanning on Screens ......................................................... - 7 -

1.4.1 No illumination detection ......................................................................... - 7 -

1.4.2 Prevention of flicker ................................................................................. - 7 -

1.4.3 Prevention of specular reflection .............................................................. - 7 -

1.5. Configure Data Transmission Interval ........................................................... - 8 -

2. INTERFACE......................................................................................................... - 9 -

2.1. RS232 options ................................................................................................ - 9 -

2.1.1. Baud rate settings................................................................................... - 10 -

2.1.2. Data, parity and stop bits ....................................................................... - 11 -

2.1.3. Handshaking .......................................................................................... - 12 -

2.1.4. Intercharacter delay for RS232 .............................................................. - 14 -

2.2. Keyboard wedge/USB options ..................................................................... - 15 -

2.2.1. Keyboard language ................................................................................ - 16 -

2.2.2. Special options ....................................................................................... - 17 -

2.2.3. Intercharacter delay for wedges/USB .................................................... - 19 -

3. CODE OPTIONS ................................................................................................ - 20 -

3.1. Setting of readable codes.............................................................................. - 21 -

3.1.1. Enabling a single read. code .................................................................. - 21 -

3.1.2. Enabling of readable codes .................................................................... - 25 -

3.2. Setting of number of characters ................................................................... - 28 -

3.3. Setting code specific options ........................................................................ - 33 -

3.3.1. Options for UPC-A ................................................................................ - 34 -

Related product manuals