AK500 System Installation and User's Guide
Positron Access Solutions 86 Document 180-0037-003 R01
For each pair's tip and ring, the current in milliamps is indicated on itself an
between that pair and every other pair being used in the AK500 system. The
screen shot above shows a normal result. There should be current flowing
between Pair1 and T1and R1, between Pair 2 and T2 and R2. The current flow
numbers should be close in value. Large differences in the current flow values
indicate a problem with that pair. No current should be flowing between pairs. If
there is current flowing between pairs, this indicates a problem with those pairs,
possible a short.
To Next Page
Loading...