G1002-C Quick Installation Guide
Positron Access Solutions 13 Document 180-0219-001 R01
• Do not attempt to disassemble the G1002-C / G1002-C+. These products
do not contain consumer-serviceable components. Only Certified Service
Centers should perform service.
• Do not use any accessories other than those approved by the manufacturer
or your service provider. Use of non-original or non-approved accessories
may result in loss of performance, damage to the product, fire, electric
shock or injury, and may violate regulations. The warranty does not cover
product failures resulting from use of non-original or non-approved
accessories.
Intended Use
Approved for use in an indoor location only
Power Supply
• Ensure that a suitable AC power outlet is located near the G1002-C or
G1002-C+ and easily accessible.
• Connect the power supply cord only to the AC power outlet that meets the
specifications marked on the AC power adapter and connect the DC
connector to the inlet of the G1002-C / G1002-C+.
• Never alter the AC power cord. If necessary, have the correct outlet installed
by a qualified electrician or call your service provider for assistance.
• To reduce risk of damage to the electric cord, remove it from the outlet by
holding onto the AC power adapter rather than the cord. Make sure to
position the cord such that it is not stepped on, tripped over or otherwise
subjected to damage or stress.
Declaration of Conformity
Hereby, the manufacturer declares that this product (G1002-C, G1002-C+) is in
conformity with the requirements and other relevant provisions of the following
European directives for the CE mark:
• 1999/5/EC: R&TTE Directive
• 2006/95/EC: Low Voltage Directive
• 2004/108/EC: Electromagnetic Compatibility Directive (EMC)
To Next Page
Loading...
Need help?
General