2.4 String Options (Prefix & Suffix)
This section describes the alterations which can be made to the format of
the transmitted data string. A prefix and suffix of 10 direct inputs may
be included in front of and at the end of the scanned barcode.
Format
{Prefix} {Code ID} {Bar Code} {Suffix}
How to set up a prefix?
To configure “#“as a prefix
(1) Scan "Start Configuration"
(2) Scan "Preamble"
(3) Scan "2" then "3" from the HEX
table. (p. 61)
(4) Scan "Confirm Configuration"
(5) Scan "End Configuration"
How to set up a suffix?
To configure “$$” as a suffix
(1) "Start Configuration"
(2) Scan "Postamble"
(3) Scan "2" then "4" from the HEX
table twice. (p. 61)
(4) Scan "Confirm Configuration"
(5) Scan "End Configuration"
To Next Page
Loading...
