Most of time the scanner only requires one barcode when changing to
new values. You will hear two beeps when you successfully change a
setting. For some special settings, multiple barcodes are needed to
complete the configuration. When using these special settings, you might
need to read one or more barcodes, such as:
Hexadecimal barcodes. For example: prefix, suffix, etc.
Numeric barcodes. For example: inter-character delay, max/min length
To complete changing the setting you will need to scan the “Confirm”
barcode after scanning from the hexadecimal table. Below is the flow chart
for the two different types of configuration.
To Next Page
Loading...
