Smart RTH button
● Press the button to start the RTH, the remote controller makes a beep sound and the aircraft will
fly back to the recorded Home Point.
● Press the RTH button again to exit RTH procedure and regain control of the aircraft.
● For more information about RTH, please turn to Return to Home section.
Emergency stop
Press the “ ” button for 3 seconds to stop the flight urgently ONLY when the aircraft encounters
emergency, or the aircraft will drop down or be crashed.
Low battery warning
Pic. 1 Pic. 2
● When the battery icon “ ” is shown on the LCD screen (Pic. 1) with steady “beep beep beep...
beep beep beep” sound, it means that the aircraft battery is nearly low voltage. At this time, the
aircraft front lights glow solid on and rear lights flash slowly. The aircraft will perform smart RTH
when the altitude is over 50m or the distance is over 100m.
● When the battery icon “ ” is shown on the LCD screen (Pic. 2) with steady “beep ...beep” sound,
it means that the aircraft battery is in low voltage. At this time, the aircraft front lights glow solid on
and rear lights flash rapidly. The aircraft will return when the altitude is over 15m or the distance is
over 15m; if either the flying altitude or flying distance is less than 15m, the aircraft will land to the
ground.
Potenstic D88 User Manual
-17-
To Next Page
Loading...
