- 12 -
FAQ
Problems
Causes
Solutions
Turn on the aircraft and the
remote control, the tail light will
keep on red. But there is no
reaction during operation.
The frequency of the remote
control is not matched with the
aircraft successfully.
Do the frequency matching
again.
After inserting the battery of the
aircraft, there is no reaction after
starting up.
1. Check whether the remote
control and aircraft are
powered on.
2. Check the battery power.
3. Poor contact between positive
and negative electrodes of
battery.
1. Make sure the batteries of
remote control and aircraft are
installed in place.
2. Use a fully charged flight
battery.
3. Replace the battery to ensure
good contact between the
battery and the electrode part.
When the throttle stick is pushed
up, the motor does not rotate,
and the tail light of the aircraft
flashes slowly.
Drone power is low. Charge the battery or replace a
new battery.
Drone propellers can rotate but
the drone can not fly up.
1. Propeller A and B is installed
reversed.
2. Drone power is low.
1. Install the propellers according
to the right marks.
2. Charge the battery or replace
a new battery.
The aircraft vibrated violently
after takeoff.
1. Blade deformation.
2. The screw fixing the motor is
loose.
1. Replace blades.
2. Tighten the screws.
The direction has been adjusted
and fine tuned, but the fuselage
will still rotate, and the left and
right rotation speed of the aircraft
is different.
1. Blade deformation.
2. Poor motor.
1. Replace blades.
2. Contact after sales.
The aircraft will move forward
or backward.
The ground is uneven when the
plane did the level calibration.
Re-calibrate the aircraft on level
ground.
The aircraft couldn't fly after it fell. 1. The blade is loose or deformed.
2. The battery is loose.
1. Replace blades.
2. Reassemble the battery and
calibrate the aircraft.
1
2
3
4
5
6
7
8
Appendix
To Next Page
Loading...
