EasyManua.ls Logo

Poulan Pro 220 - User Manual

Poulan Pro 220
18 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
220 / 260
WARNING:
Read and follow all Safety Rules and Operating Instructions before
using this product. Failure to do so can result in serious injury.
ADVERTENCIA:
Lea el manual de instrucciones y siga todas las advertencias e en-
strucciones de seguridad. El no hacerlo puede resultar en lesiones
graves.
AVERTISSEMENT:
Lire le manuel d’instructions et bien respecter tous les avertisse -
ments et toutes les instructions de sécurité. Tout défaut de le faire
pourrait entraîner des blessures graves.
Electrolux Home Products, Inc.
104 W arren Road
Augusta, GA 30907
ENGLISH
ESPAÑOL
FRANÇAIS
530164817 6/16/04
R
Electrolux Canada Corporation
6150 McLaughlin Road
Mississauga, ON L5R 4C2
Copyright E2004 Electrolux Home Products, Inc.
For Occasional U se On ly
Instruction Manual
Manual de Instrucciones
Manuel d’Instructions

Questions and Answers

  • R
    Richard ContrerasJul 26, 2025
    What to do if my Poulan Pro 220 Chainsaw engine will not start?
    • J
      Julie Jones DDSJul 26, 2025
      If your Poulan Pro Chainsaw engine won't start or runs only briefly, here are a few things to check: * Ensure the ignition switch is in the ON position. * Make sure the fuel tank isn't empty; if it is, fill it with the correct fuel mixture. * A spark plug that is not firing can also cause this issue; install a new spark plug. * Check if fuel is reaching the carburetor. A dirty fuel filter should be replaced and kinked or split fuel lines should be repaired or replaced. * The engine may be flooded. Refer to the “Difficult Starting” section in the Operation Section.
  • S
    Sydney WhitakerAug 1, 2025
    What to do if Poulan Pro 220 will not idle properly?
    • R
      Rose JohnsonAug 1, 2025
      If your Poulan Pro Chainsaw engine will not idle properly: * The carburetor may need adjustment; see “Carburetor Adjustment” in the Service and Adjustments Section. * Worn crankshaft seals can also cause idling issues; contact an authorized service dealer.
  • A
    Amy MunozAug 6, 2025
    Why does my Poulan Pro 220 Chainsaw chain move at idle speed?
    • S
      Stephen BrownAug 7, 2025
      If the chain on your Poulan Pro Chainsaw moves at idle speed: * The idle speed may need adjustment; see “Carburetor Adjustment” in the Service and Adjustments Section. * The clutch may require repair; contact an authorized service dealer.
  • A
    Alexander RodriguezAug 12, 2025
    Why Poulan Pro Chainsaw engine will not accelerate?
    • K
      kelly43Aug 13, 2025
      If your Poulan Pro Chainsaw engine lacks power, won't accelerate, or dies under load: * Begin by cleaning or replacing the air filter. * Clean, regap, or replace the spark plug. * Ensure the chain brake is disengaged. * The carburetor may need adjustment; contact an authorized service dealer.
  • E
    Edwin ZamoraAug 19, 2025
    Why is my Poulan Pro 220 smoking so much?
    • T
      Tyler SchultzAug 19, 2025
      If your Poulan Pro Chainsaw smokes excessively, it's likely due to too much oil in the fuel mixture. Empty the fuel tank and refill it with the correct fuel mixture.

Summary

SAFETY RULES

PLAN AHEAD

Steps to take before using the saw.

OPERATE YOUR SAW SAFELY

KICKBACK HAZARDS

REDUCING KICKBACK RISK

Practical tips to minimize kickback incidents.

MAINTAINING CONTROL

Proper grip and body positioning for chainsaw control.

CHAIN BRAKE AND CKA

CHAIN TENSION ADJUSTMENT

FUELING & LUBRICATION

STARTING THE ENGINE

STARTING A WARM ENGINE

Specific steps to start a warm chainsaw.

DIFFICULT STARTING PROCEDURES

Troubleshooting tips for starting a flooded engine.

TREE FELLING TECHNIQUES

NOTCH CUTTING FOR FELLING

Detailed steps for making the notch and felling the tree.

BUCKING FALLEN TREES

LIMBING AND PRUNING

TROUBLESHOOTING

TROUBLESHOOTING TABLE

Common problems, causes, and remedies for the chainsaw.

Poulan Pro 220 Specifications

General IconGeneral
BrandPoulan Pro
Model220
CategoryChainsaw
LanguageEnglish

Related product manuals