Poulan Pro PPB40PS - ENVIRONMENTALLY SAFE BATTERY DISPOSAL; TROUBLESHOOTING

19
The following toxic and corrosive materials
are in the batteries used in this blower battery
pack: Lithium-Ion, a toxic material.
WARNING: All toxic materials must be
disposed of in a specied manner to prevent
contamination of the environment. Before
disposing of damaged or worn out Lithium-
Ion battery packs, contact your local waste
disposal agency, or the local Environmental
Protection Agency for information and specic
instructions. Take the batteries to a local
recycling and/or disposal center, certied for
lithium-ion disposal.
WARNING: If the battery pack cracks or
breaks, with or without leaks, do not recharge
it and do not use. Properly dispose of it
replace with a new battery pack. DO NOT
ATTEMPT TO REPAIR IT!
To avoid injury and risk of re, explosion, or
electric shock, and to avoid damage to the
environment:
• Cover the battery's terminals with heavy-
duty adhesive tape.
• DO NOT attempt to remove or destroy any
of the battery pack components.
• DO NOT attempt to open the battery pack.
• If a leak develops, the released electrolytes
are corrosive and toxic. DO NOT get the
solution in the eyes or on skin, and do not
swallow it.
• DO NOT place these batteries in your
regular household trash.
• DO NOT incinerate.
• DO NOT place them where they will
become part of any waste landll or
municipal solid waste stream.
• Take them to a certied recycling or
disposal center.
TROUBLESHOOTING
ENVIRONMENTALLY SAFE BATTERY DISPOSAL
PROBLEM POSSIBLE CAUSE SOLUTION
Bar and chain running hot
and smoking.
Check chain tension. Possible
over-tensioning
Chain oil tank empty.
Tension chain. Refer back to the Chain
Tension section.
Check oil tank. Rell if empty.
Motor runs, but chain is not
rotating.
Chain tension too tight.
Re-tension chain. Refer back to Chain
Tension section
.
Check guide bar and chain
assembly.
Refer back to Replacing the Bar and
Chain section.
Check guide bar and chain
for damage.
Inspect guide bar and chain for
damage.
WARNING: Always stop unit and disconnect from the power source before performing all of
the recommended remedies below except remedies that require unit to be operating.