MANUAL CONTROLS
10
Once your battery is fully charged, and connected, your trolley is
ready to use. The control functions are detailed below.
Note: Your trolley includes a power save mode to extend the
life of your battery. After 5 minutes of sitting idle, the trolleys
display will turn o. To wake, press the forward or stop button
on the remote handset (if powered on and paired with the
trolley). Alternatively, rotate, or press the control dial.
Start and Stop the trolley: To start the motor, press the
button in the centre of the control dial. To pause the motor,
press once more.
When the motor is powered, the power indicator will change
from red to green. When the motor is paused, the speed setting
will ash, and the power indicator will turn red.
Increase and decrease Speed: Rotate the control dial to
adjust the speed of the trolley from 0 - 9. Press the control dial
to pause and resume your selected speed - there is no need to
reduce the speed setting.
Note: the motor has a 15 minute timeout function and will
pause the motor after running for this duration.
Automatic Distance Function (ADF): The ADF function is a
convenient way of sending your trolley a set distance (5 to 50
yards/metres); for example, when you are approaching a green
you can send the trolley towards the next tee if the route
allows.
Note: it is not recommended to send your trolley unattended
over steep or rough terrain.
To activate ADF the motor must be paused and then:
1. Press and hold the control dial until ADF display (left)
appears on the screen.
2. Rotate the control dial to select the distance between 5 and
50 (Yards/Metres).
3. To set the trolley in motion, press the control dial to start
the motor. The trolley will run by default at speed 4.
To cancel the ADF during set-up, rotate the control dial so “0” is
displayed as the distance to travel and conrm by pressing the
control dial or alternatively, press the red ‘CANCEL’ button on
the touchscreen.
To cancel when the trolley is in motion, simply press the control
dial to pause the motor as you would during normal use or
alternatively, press the red ‘CANCEL’ button on the touchscreen.
Note: ADF distances are approximate based on at level terrain
conditions using a fully charged battery. The overall distance
may be aected by terrain conditions, obstacles inclines,
declines, battery charge and weight of the bag.
ADF
Distance to TravelCancel Button
Central Control Dial
Touch Area
Speed Setting
Power Indicator
To Next Page
Loading...
Need help?
General
