What to do if Power Acoustik PTID-7002NR IR remote does not work?
If the IR remote for your Power Acoustik Car Video System does not work, the first thing to check is the battery. Replace the battery if it's dead. If that doesn't work, remove the battery and reinstall it correctly.
What causes excessive skipping on Power Acoustik PTID-7002NR Car Video System?
If your Power Acoustik Car Video System experiences excessive skipping, first check the mounting sleeve to ensure the unit is mounted correctly. Also, inspect the media for scratches or physical defects.
Why Power Acoustik PTID-7002NR Car Video System has audio when in reverse?
If your Power Acoustik Car Video System has audio only when in reverse, it is likely due to the parking brake safety circuit not being connected. Check the connections at the parking brake. Also, ensure that the parking brake is applied.
Why Power Acoustik PTID-7002NR resets itself when engine is off?
If your Power Acoustik Car Video System unit resets itself when the engine is off, the issue is likely due to an incorrect connection between the ACC and positive battery wire. Check the wiring and correct it to resolve this problem.
How to improve sound quality on Power Acoustik PTID-7002NR?
If your Power Acoustik Car Video System exhibits poor sound quality or distortion, it might be due to incompatible speakers. Ensure that the speaker power rating is compatible with the unit and connect proper speakers. Also, check the speaker wire contact, as a shorted speaker can cause this issue.
Why Power Acoustik Car Video System has power but no audio output?
If your Power Acoustik Car Video System has power but the audio output is low or nonexistent, start by checking the speaker wire connections at the speakers. Also, make sure that none of the speaker wires are touching each other or the chassis ground; if they are, insulate all bare speaker wires. Finally, review the wiring diagram and check for damaged speakers.
What to do if Power Acoustik Car Video System unit blows fuse?
If your Power Acoustik Car Video System unit blows a fuse, it could be due to a few reasons. Check if the yellow or red wire is touching the chassis ground, indicating a pinched wire. Also, inspect the speaker wires to ensure they aren't touching the chassis ground. Finally, verify that you are using a fuse with the correct rating and replace it if necessary.
General| Display Size | 7 inches |
|---|---|
| Resolution | 800 x 480 pixels |
| Touchscreen | Yes |
| DVD Player | Yes |
| Navigation | No |
| Bluetooth | Yes |
| USB Port | Yes |
| SD Card Slot | Yes |
| AV Input | Yes |
| Radio Tuner | AM/FM |
| Rear Camera Input | Yes |
| Video Input | Yes |
| Media Format | MP3, WMA, JPEG |
Critical warning about using correct fuse ratings to prevent unit damage.
Identifies the main connection ports on the unit.
Explains the function of each wire in the main wiring harness.
Step-by-step guide for the first method of installing the unit.
Steps to install the unit using a back strap and securing with screws.
Explains the function of each button on the front panel.
Detailed explanation of each button's function on the remote.
Step-by-step process to calibrate the touch screen for accurate input.
Explains how to select different modes like DVD, Radio, NAVI, and iPod from the main menu.
Explains the interface and controls for operating the radio.
Explains the interface and controls for operating the DVD player.
Process to calibrate the touch screen for the navigation system.
Instructions on accessing the navigation mode from the main menu.
Solutions for common issues like no power, low audio, or unit resetting.
Solutions for video display problems and disc playback errors.
To Next Page
