Why is there no repeat or searching while playing VCD on my Power Acoustik PTID-7350NR Car Video System?
If there is no repeat or searching available while playing a VCD on your Power Acoustik Car Video System, it might be because PBC is turned on. Turn PBC off.
Why is there no or low audio output from my Power Acoustik Car Video System?
If you're experiencing no or low audio output from your Power Acoustik Car Video System, it could be due to several reasons. First, check the wiring of your audio output connection and correct it if necessary. Make sure the volume isn't set too low and increase it if needed. The speakers might be damaged, requiring replacement. Also, check if the volume balance is heavily biased and adjust the channel balance to the center position. Finally, ensure that the speaker wiring is not in contact with any metal part of the car, and insulate all speaker wiring connections if needed.
What to do if the remote control for my Power Acoustik Car Video System does not work?
If the remote control for your Power Acoustik Car Video System is not working, the battery may be depleted. Try replacing it with a new one. Also, check if the battery is installed correctly; if not, remove it and reinstall it properly.
Why does my Power Acoustik PTID-7350NR unit reset itself when the engine is off?
If your Power Acoustik Car Video System unit resets itself when the engine is off, it might be due to an incorrect connection between the ACC and the positive battery wire. Check the wiring and correct it.
Why is the sound quality poor or distorted on my Power Acoustik PTID-7350NR Car Video System?
Poor sound quality or distortion on your Power Acoustik Car Video System could be due to a pirate disc being used; use an original copy instead. It may also be caused by speaker power ratings not compatible with the unit, so connect proper speakers. Finally, check the speaker contact, as the speaker might be shorted.
What to do if I see a flashing image or interference on the screen of my Power Acoustik PTID-7350NR?
If you are experiencing a flashing image or interference on the screen of your Power Acoustik Car Video System, the DVD may not be compatible with the current TV system settings. Try changing the setup to accommodate the disc.
Why does my Power Acoustik PTID-7350NR say 'Bad Disc'?
If your Power Acoustik Car Video System displays 'Bad Disc,' it may be because the disc is dirty, so clean the disc with a soft cloth. It could also mean the disc is upside down, so insert the disc with the label side up.
What does 'Error' mean on my Power Acoustik PTID-7350NR Car Video System?
If your Power Acoustik Car Video System displays 'Error,' it indicates an illegal mechanism operation. Press the EJECT key for 5 seconds to reset the loading mechanism.
Why is the image blurred, distorted, or dark on my Power Acoustik PTID-7350NR Car Video System?
If the image on your Power Acoustik Car Video System is blurred, distorted, or dark, it might be because the disc is illegally copied. Try using an original disc.
What to do if I cannot insert a disc into my Power Acoustik PTID-7350NR Car Video System?
If you cannot insert a disc into your Power Acoustik Car Video System, it is possible that a disc is already inside the unit. Eject the current disc and then insert the new one.
General| Screen Size | 7 inches |
|---|---|
| Resolution | 800 x 480 pixels |
| Touchscreen | Yes |
| DVD Playback | Yes |
| USB Input | Yes |
| SD Card Slot | Yes |
| Bluetooth | Yes |
| AV Input | Yes |
| Navigation | No |
| Radio Tuner | AM/FM |
| Steering Wheel Control Compatible | Yes |
| Rear Camera Input | Yes |
| Video Input | Yes |
| Power Output | 50 watts x 4 |
To Next Page