Cleaning and
lubricating the shaft
The shaft must be cleaned and lubricated periodically:
Ensure the unit is disconnected from the power supply.
Remove the grinding disc protective cover.
Pull the grinding disc away from the unit using light
pressure.
Holding the wheel, clean the shaft with a brush.
After cleaning the shaft must be oiled or greased lightly
with a brush.
Lightly oil the shaft
Pull the disc
Interval Operation
Before each use • Check for signs of abrasion and damage to the
grinding disc.
• Check all cables for damage.
• Make sure you operate the Power-edge in a safe
environment
After each use • Clean the grinding dust from the unit using a soft,
dry cloth or brush.
• Allow the unit to cool down after prolonged use,
before replacing it in the case.
• After prolonged use, check for possible build-up of
hot abrasive particles under the cover and remove if
necessary.
To Next Page
Loading...