Replacing or reversing the grinding disc
The grinding disc can be ipped over or replaced when it is worn out.
Loosen the knurled retaining nuts (
f
) of the safety cover (
e
) and remove the
cover.
Hold the grinding disc (
g
) still with your thumb and forenger, then loosen the
retaining nut (
h
) with a 10 mm spanner.
Pull the grinding disc (
g
) off the shaft and ip it over or replace it.
When re-mounting the grinding wheel, simply reverse the removal procedure.
Please do not over-tighten the retaining nut – the direction of rotation while
operating stops the nut from loosening off.
e
Safety cover
f
Safety cover
retaining nuts
g
Grinding disc
h
Disc retaining
nut
To Next Page
Loading...