Position the Power-edge
With the Power-edge turned off, position it on the upturned ski/board with the
guide rollers resting on the base surface of the ski or snowboard. The Edge
guide wheels should overhang the edge of the ski/board.
At this point, keep the grinding wheel clear of the edge.
Check that the length of the ski/board is free of any obstructions that would
impede the continuous movement of the Power-edge.
Make sure the power cord has a sufciently large loop to allow free movement.
CAUTION
Ensure that there are no ammable materials
(e.g.wax) in the vicinity to avoid re risk from
sparks.
Press and hold the wheel engagement/release button to keep the
wheel away from the edge.
Rest the guide rollers on the
base of the upturned ski/board
Upside-down ski/board
Press and hold the
engage/release
button (
d
)
Edge guide wheels (
i
)
overhang the edge.
DANGER
Edge grinding creates hazardous dust!
Please wear protective goggles and a mask
when operating the Power-edge!
To Next Page
Loading...