Need help?Do you have a question about the Power Flame C1-GO-10 and is the answer not in the manual?
Explains the core principles of pressure atomization for oil and multiple orifice venturi for gas.
Details how to identify burner models based on frame size and fuel type.
Covers general requirements for sizing and installing gas and oil supply piping.
Specifies air needs and general requirements for combustion chambers.
Explains gas burner operation in On-Off, Low-High, and Full Modulation modes.
Details oil burner operation in On-Off, Fixed Fire, and Modulation modes.
Provides general start-up procedures and lists required test equipment.
Provides detailed step-by-step instructions for initiating gas burner start-up.
Offers a step-by-step guide for initiating oil burner start-up.
Covers servicing for oil nozzles, ignition systems, and gas pilots.
Addresses common problems encountered during gas and oil burner operation.
Provides a checklist of regular maintenance tasks for burner components.
Section for recording essential data during burner start-up and testing.
Lists critical safety precautions to follow before and during burner operation.
Covers preparation and step-by-step procedures for starting the burner.
General| Fuel | Gas |
|---|---|
| Fuel Type | Natural Gas |
| Turndown Ratio | 10:1 |
| Ignition Type | Direct Spark Ignition |
| Air Supply | Forced Draft |
To Next Page
