Need help?Do you have a question about the Power Flame C2-OB and is the answer not in the manual?
Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.
Guidelines for sizing and installing gas supply piping to ensure proper pressure.
Shows typical gas piping for Type C burner, On-Off, Low-High-Off and Low-High-Low systems.
Illustrates typical gas piping for Type C burner, Modulating System.
Specifies fresh air requirements for supporting combustion and ventilation.
Illustrates the operation of a gas burner with On-Off fuel/air control.
Shows the operation of a gas burner with Low-High-Off or Low-High-Low fuel/air control.
Illustrates the operation of an oil burner with On-Off fuel/air control mode.
General procedures for initial burner start-up for all fuel types.
Step-by-step instructions for starting up the gas burner.
Step-by-step instructions for starting up the oil burner.
Procedures for adjusting direct spark oil ignition electrodes.
Troubleshooting issues related to oil operation.
Troubleshooting when oil flame does not establish with direct spark ignition.
Troubleshooting flame safeguard lockouts after initial oil flame ignition.
Guidelines for preventative maintenance by qualified technicians and building personnel.
Safety precautions to follow if gas is smelled or in the vicinity of the appliance.
Key precautions to follow before and during burner operation.
Procedures for preparing and starting up the burner for all fuels.
Step-by-step instructions for starting up the gas burner.
Step-by-step instructions for starting up the oil burner.
References the maintenance section in the burner manual.
General| Brand | Power Flame |
|---|---|
| Model | C2-OB |
| Category | Burner |
| Language | English |
To Next Page