Need help?Do you have a question about the Power Flame C2-GO-20B and is the answer not in the manual?
Instructions to follow if a gas smell is detected.
Alerts to risks from improper installation, adjustment, or service.
Explains the mechanical operation of the on-off fuel/air control system.
Describes the mechanical operation of low-high fuel/air control modes.
Details the mechanical operation of the full modulation gas fuel/air control.
Explains the mechanical operation of the on-off fuel/air control mode for oil burners.
Describes the mechanical operation of the fixed air low fire start oil system.
Explains the operation of the RALFS system for oil/gas burners.
Details operation of low-high oil control using a Webster 22R pump.
Explains low-high oil control using a two-step pump.
Details the mechanical operation of the full modulation oil burner.
Provides comprehensive general start-up procedures for all fuels.
Details startup procedures for various gas/oil system combinations.
General guidance and considerations for gas burner startup.
Step-by-step instructions for starting up the gas burner.
Specific startup adjustments for modulating burners.
Step-by-step instructions for starting up the oil burner.
Common issues when the burner fails to start or experiences lockouts.
Specific troubleshooting steps for gas operation issues.
Further troubleshooting for gas operation problems.
Common issues and solutions for oil operation.
Additional troubleshooting steps for oil operation issues.
Fields for recording gas firing parameters and test results.
Fields for recording oil firing parameters and test results.
Essential safety precautions and important precautions for burner owners.
Instructions for owners to start up the burner.
General| Brand | Power Flame |
|---|---|
| Model | C2-GO-20B |
| Category | Burner |
| Language | English |
To Next Page
