Need help?Do you have a question about the Power Flame C2-G-15 and is the answer not in the manual?
Explains the basic principles of Power Flame Type C burners.
Lists standard burner ratings, capacities, and component data.
Explains the operation of an On-Off gas burner's fuel/air control.
Details the fuel/air control for Low-High-Off/Low-High-Low gas burners.
Explains the fuel/air control for full modulation gas burners.
Details the on-off fuel/air control for oil burners.
Explains the fuel/air control for oil burners with fixed air low fire start.
Details the RALFS system for oil or gas/oil burners.
Explains fuel/air control for Low-High-Off/Low-High-Low oil burners using Webster 22R pump.
General procedures for starting up all types of burners.
Step-by-step instructions for initiating gas burner start-up.
Provides curves for correlating CO2/O2 values with excess air and fuel types.
Step-by-step instructions for initiating oil burner start-up.
Section for recording gas firing parameters and test results.
Section for recording oil firing parameters and test results.
Essential safety precautions for operating the burner.
Key precautions before operating or servicing the burner.
General preparation and steps for burner start-up.
General| Fuel Type | Gas or Oil |
|---|---|
| Input Range (Gas) | 400, 000 - 2, 100, 000 BTU/hr |
| Input Range (Oil) | 2.8 - 15.0 GPH |
| Motor | 1/3 HP |
| Electrical | 120/1/60, 208-240/1/60, 208-240/3/60, 480/3/60, 575/3/60 |
| Gas Connection | 1/2" NPT |
| Oil Connection | 1/4" NPT |
| Ignition Type | Electronic Intermittent Pilot or Direct Spark Ignition |
| Control Type | Modulating |
| Air Adjustment | Adjustable Combustion Air Band |
| Flame Supervision | Ultraviolet |
| Material | Steel |
| Mounting | Flange Mount |
To Next Page