Need help?Do you have a question about the Power Flame C6-GO-30 and is the answer not in the manual?
Explains the pressure atomization for oil and multiple orifice, venturi operation for gas.
Identifies components of a typical gas/oil burner with on-off fuel/air control.
Covers general guidelines and considerations for gas supply piping installation.
Illustrates the mechanical operation of a gas burner with on-off fuel/air control.
Illustrates the mechanical operation of a gas burner with low-high-off/low-high-low control.
Illustrates the mechanical operation of a gas burner with full modulation control.
Illustrates the mechanical operation of an oil burner with on-off fuel/air control.
Illustrates the mechanical operation of an oil burner with fixed air low fire start.
Illustrates the mechanical operation of an oil/gas burner with reduced air, low fire start.
Illustrates the mechanical operation of an oil burner with low-high-off/low-high-low control.
Illustrates the mechanical operation of an oil burner with a two-step pump.
Illustrates the mechanical operation of an oil burner with full modulation control.
Outlines general procedures and recommendations for burner start-up.
Outlines step-by-step instructions for gas burner start-up sequences.
Details specific start-up adjustments for burners designed for full modulation.
Outlines step-by-step instructions for oil burner start-up sequences.
Details internal bypass oil nozzle systems, their operation, and pressure ratings.
Lists recommended periodic checks for burner components and settings.
General preparation steps before starting the burner for all fuels.
General| Brand | Power Flame |
|---|---|
| Model | C6-GO-30 |
| Category | Burner |
| Language | English |
To Next Page
