Need help?Do you have a question about the Power Flame C4-GO-30 and is the answer not in the manual?
Explains the basic principles of pressure atomization for oil and multiple orifice venturi operation for gas.
Outlines essential general procedures for burner start-up applicable to all fuel types.
Provides guidance on adjusting fuel/air modes for combination gas/oil burners.
Step-by-step instructions for performing the gas burner start-up sequence.
Step-by-step instructions for performing the oil burner start-up sequence.
Lists common oil pump issues and their troubleshooting solutions.
Lists common burner start-up failures and occasional lockout causes.
Covers issues related to pilot ignition and main gas flame establishment in gas operation.
Addresses problems with oil flame ignition, scanning, smoke, and transition to high fire.
Crucial safety instructions to follow during burner operation.
Key precautions to observe when operating or maintaining the burner.
General preparation and specific steps for starting gas, oil, or combination burners.
General| Turndown Ratio | 3:1 |
|---|---|
| Firing Rate (Natural Gas) | 4, 200, 000 - 12, 600, 000 BTU/hr |
| Fuel Type | Natural Gas, No. 2 Oil |
| Input Range | 4.2 - 12.6 MMBTU/hr |
| Ignition Type | Direct Spark |
| Air Delivery | Forced Draft |
To Next Page
